USB Motor controller MC02 PCB

mc2

The MC02 motor controller board is a nice and economic way to control a small stepper motor.

This board is very simple, both to use and to mount into your mechanics.

It is shipped with a software that permits three ways of operation:

  • Full-step motor control
  • Half-step motor control
  • Microstep motor control

The MC02 can be controlled by using an USB cable, using the WinUSB serial interface, or by using the two pins on the rear part of the board.

The motor outputs can reach  up to 1A each winding.

Two led indicators show you the actual power and operating status of the device.